BTT Octopus and Raspberry pi 3B+ for Weedo x40
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Uses the old mounting points to mount a BTT Octopus and Raspberry pi inside the electronics housing.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 243
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Octopus Mount:
Requires 8 M3 bolts (4 of which can be used from the original board mounting).
Also uses 4 M3 nuts that press-fit into the hexagonal holes on the bottom. To install the nuts align them with the holes and then flip the part upside down so the nuts are on a table and then press down, they should snap into place.
Raspberry pi 3B+
Similar to the octopus mount, 8M3 bolts are needed and 4 M3 press-fit nuts are used. Also has a 'filler' that fills the void otherwise left by the screen. **Note some sanding and/or filing may be needed on the slot for the filler part on the mount because the dimensions and alignments are not perfect.