Wand Vibrator Wall Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount your favorite wand vibe in a more accessible way
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 108
- Wydruki
- 0
- Wyświetlenia
- 863
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Medical Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
Thought I could make some slight improvements to dasNessie's mount for Hitachi wands, so I changed a few things:
-Thinned the prongs for better compatibility with other brands of vibrating wands that don't tend to have such a large gap between the head and wand, which means it should fit both full-sized wands and the smaller, roughly hand-sized type, too.
-Removed most of the back wall where it wasn't as necessary since I changed the mounting to use screws rather than 3m/double sided tape
-Added a couple reinforcing bits between the wall and the prongs, just in case
-Added little nubs on the ends of the prongs just to help retain wands
For printing, I recommend 25%-35% infill, just for structural integrity. It is a wall mount after all, and be careful not to screw it in too tightly as it might snap the walls of the print along the layer lines.