Wand Vibrator Wall Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mount your favorite wand vibe in a more accessible way
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 108
- Makes
- 0
- Views
- 863
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Medical Tools
- License
- Creative Commons — Attribution — Noncommercial
Thought I could make some slight improvements to dasNessie's mount for Hitachi wands, so I changed a few things:
-Thinned the prongs for better compatibility with other brands of vibrating wands that don't tend to have such a large gap between the head and wand, which means it should fit both full-sized wands and the smaller, roughly hand-sized type, too.
-Removed most of the back wall where it wasn't as necessary since I changed the mounting to use screws rather than 3m/double sided tape
-Added a couple reinforcing bits between the wall and the prongs, just in case
-Added little nubs on the ends of the prongs just to help retain wands
For printing, I recommend 25%-35% infill, just for structural integrity. It is a wall mount after all, and be careful not to screw it in too tightly as it might snap the walls of the print along the layer lines.