HSW Tape Holder (38x15 mm)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small tapes holder for Honeycomb Storage Wall.
- Ocena
- 4,5 / 5
- Polubienia
- 120
- Pobrania
- 390
- Wydruki
- 3
- Wyświetlenia
- 1605
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Small tapes holder for Honeycomb Storage Wall. Designed for tape rolls 15mm wide, and with 38mm internal diameter (e.g., electrical tapes). Attaches to HSW M3 insert with an M3 metric screw (requires also an M3 hex nut).
Inspired by @Super7's Tape Hook, but modeled from a scratch.
HSW M3 insert is copied directly from @RostaP's insert-with-M3 model.
Print instructions
Print it with it's back down. No supports needed.
I printed mine in PETG with 6mm nozzle, and 4mm layer height; however, any other combination of material, nozzle diameter, and layer height should work - this is a very simple model, so there are basically no restrictions.