1 / 20
Dragster Air Scoop and Mount/Arrestor For Dominator 4500 Series Carburetor — zdjęcie 1
1 / 20

Dragster Air Scoop and Mount/Arrestor For Dominator 4500 Series Carburetor

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Complete Dragster Scoop with Plug, Mount, Screen/Arrestor. Mounting Plate was CNC'd, the rest is printed.

Ocena
0 / 5
Polubienia
13
Pobrania
110
Wydruki
0
Wyświetlenia
1076
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a dragster style carburetor scoop I designed for my boat. It requires quite a bit of post-processing to make it look finished. The Mounting Plate was cut from ¼ inch polycarbonate on a CNC router. The rest of the parts are printed. You will need various ¼-20 screws, taps and washers to assemble. 

Printed Parts:

ABS or PETG- Scoop Assembly, Mount Upper and Lower, Screen/Arrestor, Flange Riser, Plug

TPU- All Gaskets

Nylon CF- Mounting Brackets

 

Mount upper and lower require support. Scoop assembly parts required brims. Scoop alone is roughly 40 hours of printing an uses about 1500g of filament.  I printed everything at default generic settings 0.20mm layer height. Screen/arrestor was printed at 50% hex infill with 0 top and bottom layers and 5 walls.

 

Scoop assembly was printed on 7 plates with Bambluab X1C (256x256x256mm).

 

Assembly of scoop: 

Fine sanding and glue parts together, using CA glue and activator spray. Use masking tape to clamp parts together while gluing. Sand glue joints. 

 

Post-Processing/Painting:

Once assembled, sand and coat with resin/hardener mixed to the correct ratio inside and out. Allow excess to drip off. I did this process twice and sanded between coats. Then, apply drywallers fiberglass tape to inside and re-coat with resin.  Use bodyfiller to fix exterior surface deviations and sand. Re-coat exterior with resin and sand. Apply 2- coats of automotive filler primer and sand up to 800 grit sandpaper.  Spray inside with black paint, mask and spray exterior with desired final color.  Re-coat interior and exterior with a carefully applied coat of resin. Use a torch to carefully extract bubbles from the resin. This step provides the final gloss over the paint. I used West System epoxy resin. Once mounting plate is assembled, holes will need to be drilled for ¼-20 screws in the scoop to mount it to the base. Mounting bracket screws will need to be tapped to accept the ¼-20 screws, along with the corresponding holes in the CNC'd Mounting Plate.

 

Tagi