1 / 20
Dragster Air Scoop and Mount/Arrestor For Dominator 4500 Series Carburetor — image 1
1 / 20

Dragster Air Scoop and Mount/Arrestor For Dominator 4500 Series Carburetor

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Complete Dragster Scoop with Plug, Mount, Screen/Arrestor. Mounting Plate was CNC'd, the rest is printed.

Rating
0 / 5
Likes
13
Downloads
110
Makes
0
Views
1,076
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution — Noncommercial — Share Alike

This is a dragster style carburetor scoop I designed for my boat. It requires quite a bit of post-processing to make it look finished. The Mounting Plate was cut from ¼ inch polycarbonate on a CNC router. The rest of the parts are printed. You will need various ¼-20 screws, taps and washers to assemble. 

Printed Parts:

ABS or PETG- Scoop Assembly, Mount Upper and Lower, Screen/Arrestor, Flange Riser, Plug

TPU- All Gaskets

Nylon CF- Mounting Brackets

 

Mount upper and lower require support. Scoop assembly parts required brims. Scoop alone is roughly 40 hours of printing an uses about 1500g of filament.  I printed everything at default generic settings 0.20mm layer height. Screen/arrestor was printed at 50% hex infill with 0 top and bottom layers and 5 walls.

 

Scoop assembly was printed on 7 plates with Bambluab X1C (256x256x256mm).

 

Assembly of scoop: 

Fine sanding and glue parts together, using CA glue and activator spray. Use masking tape to clamp parts together while gluing. Sand glue joints. 

 

Post-Processing/Painting:

Once assembled, sand and coat with resin/hardener mixed to the correct ratio inside and out. Allow excess to drip off. I did this process twice and sanded between coats. Then, apply drywallers fiberglass tape to inside and re-coat with resin.  Use bodyfiller to fix exterior surface deviations and sand. Re-coat exterior with resin and sand. Apply 2- coats of automotive filler primer and sand up to 800 grit sandpaper.  Spray inside with black paint, mask and spray exterior with desired final color.  Re-coat interior and exterior with a carefully applied coat of resin. Use a torch to carefully extract bubbles from the resin. This step provides the final gloss over the paint. I used West System epoxy resin. Once mounting plate is assembled, holes will need to be drilled for ¼-20 screws in the scoop to mount it to the base. Mounting bracket screws will need to be tapped to accept the ¼-20 screws, along with the corresponding holes in the CNC'd Mounting Plate.

 

Tags