Shelly box for T&E 3x slots and wago 221 connectors (1Plus, 1L, 2PM, 2.5, Dimmer2)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Enclosure designed to hold a Shelly for wiring light fittings using the UK 3 wire system with wago 221 connectors.
- Ocena
- 5 / 5
- Polubienia
- 86
- Pobrania
- 608
- Wydruki
- 2
- Wyświetlenia
- 5418
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Part of my series of enclosures designed for Shelly smart devices and Wago 221 connectors.
- Shelly box for T&E 3x slots and wago 221 connectors (this one)
- Shelly box for inline flex wire and wago 221 connectors
- Shelly box for 2x flex wires and wago 221 connectors
- Shelly box for 3x flex wires and wago 221 connectors
- Shelly quad box for 2x devices/5x relays/5x flex wires and wago 221 connectors
Shelly box for T&E 3x slots and wago 221 connectors
This box was designed for wiring light fittings using the UK wiring model (feed/switch/load) on twin&earth wire with wago 221 connectors, but it can be used for other purposes. The box supports Shelly Plus1, 1L, 2.5, 2PM, Dimmer devices.
Electrical safety
- Mains electricity carries danger of death. Please don't attempt to use one of these with real circuits unless you are competent and aware of health and safety procedures.
- Use PETG or other fire resistant materials other than PLA.
Purpose and features
The enclosure is designed to connect 3 twin&earth wires to 1 shelly device using 3 wago 221 connectors. The wires will serve the functions of providing feed power, external switching and a connection to the load.
Shelly device support: Shelly Plus1, Shelly 1L, Shelly 2.5, Shelly 2PM, Shelly Dimmer2
Wire strain relief: Each flex wire entry port has slots for fitting a cable tie as strain relief for the wires.
Attachment holes: The box has counter-sunk holes to attach it to a surface.
Cooling slots: There are cooling slots all around and above/below the shelly device.
Lid fitting: The lid attaches to the box using 4x M3 screws (5-10mm max) which thread into M3 heat inserts to be installed on the box.
Printing notes
- The lid requires supports on the bolt hole counter-bores, otherwise it will not print cleanly (in my case it didn't)
Version control
Version 2.1 - 11/03/2024
- Updated (reduced) cable tie shelf width
- Re-shaped lid to fit (issue in v2.0)
Version 2 was a significant redesign to include the following features:
- M3 heat thread inserts instead of square nut slots or holes for tapping
- Attachment bolt holes on the inside of the box rather than outside brackets
- Cable tie pads inside the box as opposed to accessible from the outside (enables refitting ties without dismounting the box)
- Shelly slot adjusted for compatibility with multiple models