HSW Panasonic BQ-CC65 battery charger mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a simple HSW mount for the Panasonic BQ-CC65 battery charger.
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 90
- Wydruki
- 2
- Wyświetlenia
- 586
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
This is a simple Honeycomb Storage Wall mount for the Panasonic BQ-CC65 battery charger.
To mount it, you'll need two M3 screws and either two original inserts with M3 nut or my variant of the inserts that use square nuts (https://www.printables.com/model/398581-insert-for-hsw-with-m3-square-nut).
Printed with PETG, because it needs to be bent quite a lot in order to fit it on the charger.
Mount it on the HSW first, because screws would be inaccessible after you fit the charger in.
I recommend putting some rubber or foam tape on the back side to eliminate any potential wobbling, but it is unnecessary.
Lastly, plan to mount the charger somewhere on the top of your HSW. The display is readable only directly from the front or bottom. So if you mount it too low, you'll be unable to read anything from it. See the last two photos to see the effect.