Odroid M1 enclosure with 3.5" HDD
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3D printed enclosure for the board, a 3.5" HDD and 80mm fan
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 1164
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This project requires:
- Odroid M1 with 12V power supply
- 3.5" HDD, angled SATA cable, custom power cable
- 80mm fan with USB connector
- 14 threaded inserts (M3, 5mm diameter, 4-8mm long)
- 10x M3 x 10mm screw
- 4x M3 x 16mm screw
- 4x Mx30mm screw (35mm also works)
- 250-300grams of PETG
You will have to make your own power cable for the HDD. Cut off a cable that has an angled SATA power connector, crimp a JST XH connector on the cable. It's recommended to mount the HDD upside down.
You have to bridge the 12V from the PSU to the HDD power connector. WATCH OUT, connecting a higher voltage power supply will kill the HDD. See https://forum.odroid.com/viewtopic.php?p=359208#p359208
It's easiest if you use an USB 80mm fan. You can ziptie the cable to the enclosure.
Photos of the HDD bay are from a slightly different version.
STEP file included. See technical drawing for mounting holes on the bottom side.