Single Thumbwheel Counter (00 to 99) using a Geneva Drive.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A counter from 00 to 99. Useful as a MTG life counter among other things.
- Ocena
- 5 / 5
- Polubienia
- 168
- Pobrania
- 499
- Wydruki
- 13
- Wyświetlenia
- 3230
- Oceny
- 12
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial
Support:
The case_bottom needs support. Nothing else requires support. Carefully remove the support in the case bottom before assembly. Printing the Geneva gear at 0.12 layer height is recommended for smoother operation as z-seams negatively impact smoothness of the mechanism. The rest can be printed at 0.12 or 0.20 layer height.
Assembly:
Put the middle moon gear in the case bottom gear side down, then point the peg on the moon gear at 45 degree angle away from the thumbwheel. Next put in the thumb_gear with the 0 at the innermost number, then add the Geneva wheel with zero at the center. If the post on the middle gear is aligned, it should slide together easily without forcing. Check the alignment of the numbers to make sure the tens place rolls over as expected and then and press on the top case to hold it all together via friction fit.
If the movement sticks, smooth out Z-seams.
This is a remix of:
https://www.thingiverse.com/thing:4097275
which was a remix of:
https://www.thingiverse.com/thing:1290507
Enjoy!