Voron Trident Webcam Mount for NexiGo N980P
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Webcam mount for the bare PCB of the NexiGo N980P webcam. This nestles the camera in the top corner out of the way.
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 34
- Wydruki
- 2
- Wyświetlenia
- 506
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
If you're willing to strip the plastic housing off of your NexiGo N980P, you can use this model to mount the PCB in either the front left or right top corner of your printer (or, the back is probably ok too). Use two of the zip ties from your printer supplies to secure the cord and keep strain off of the plug on the PCB. Two M4 t-nut or roll-in nuts can be used to mount to the frame. I found that M4x8 button head bolts worked well. Additionally, four M3x5 or M3x6 bolts can be used to secure the PCB into place.
The aim should work well for all three standard sizes (250, 300, and 350). I suspect that the webcam is aimed too high for a Voron 2.x but it can't hurt to try.
Printing this model shouldn't require any supports as long as you can tackle 45° overhangs and your bridging is ok. I liked the model at 4 walls but 3 is probably OK. I wouldn't expect any adhesion issues printing in ABS since it's not that big of a part.
Disassembly tip for the webcam: start by taking off the front printed plate. A few screws are hidden behind that sheet of plastic. Be careful pulling the cord out of its hole. I'd unplug it from the PCB, remove the PCB, then very carefully use flush cutters to cut away the shoe that mounts it through the case.