Bracket for Schunk APS-Z80 Proximity Sensor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This was designed to replace an existing magnetic proximity sensor bracket.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 120
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
This was designed to replace an existing magnetic proximity sensor bracket that the recessed nut stripped out of which caused the proximity sensor to begin slowly backing itself out of position. This small print needs supports to keep the dimensions of the holes relatively close to what they should be. The M3 nuts I had on hand measured .090" thick so this bracket is made with that in mind. 3 M3 bolts and an M3 nut are required to remount this to the robotic head it belongs to. The sensor threads in.
Category: Robotics