Dyson V11/V10/V8/V7 Accessory Mount/Holder - Modded
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a reinforced version of the great Accessory holder by albrnick. I tried 2 times to print and use the original…
- Ocena
- 3,9 / 5
- Polubienia
- 36
- Pobrania
- 341
- Wydruki
- 9
- Wyświetlenia
- 1285
- Oceny
- 10
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
This is a reinforced version of the great Accessory holder by albrnick.
I tried 2 times to print and use the original version, but accessories cause a breaking on the support between the two holders after a couple of weeks.
So I edited the original version adding a bigger support.
I also put a reinforcement where the holder goes inside the original dyson base. This causes this holder to be VERY strong and could be a bit difficult to remove it from the base after put inside.
Attached there is only the "left" version, you can mirror it for the right one.
I tested it with Dyson V11, it should be compatible also with V10, V8 and V7 like the original one.
I printed with PLA, so I used an infill of 50% for have the support as stronger as I can.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
50%
Notes:
I used brim with tree supports.
Category: Household