Sunfounder 7" Display Mount for Voron 2.4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount for 7" touchscreen display that tucks out of the way of your doors
- Ocena
- 1 / 5
- Polubienia
- 7
- Pobrania
- 97
- Wydruki
- 0
- Wyświetlenia
- 853
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution
General Details
I've included two models - one that uses heat-set inserts and one that threads into plastic. The heat-set inserts are preferred, but you do you. My inserts are 4.7mm in diameter and 5.6mm tall so that's what the model is designed for. I've included the STEP file if you need to remix.
It's recommended that you use right-angle connectors for the cables coming out of the display (be mindful of the connector orientation before you buy!). You can use zip ties to run cables through the centre of the mount, just make sure nothing binds up before committing.
The inlays are intentionally placed upside down on the bed since I wanted the smooth finish of my PEI plate. I used a toothpick to apply superglue afterwards and they've been solid.
The mount and its instructions/BOM can be found here, but I've included a copy of the STLs just in case.
Print Settings
This is a TIGHT fit. If you use ABS/ASA, I'd consider adding a 0.5% X/Y shrink compensation if you haven't already. If you're using heat-set inserts, be careful with alignment. Other than that, your existing Voron settings should be more than sufficient.