1 / 3
Brillar LED Remote Control Wall holder — zdjęcie 1
1 / 3

Brillar LED Remote Control Wall holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is for the STL of an Brillar LED Control wall mount. I couldn't find this anywhere so designed it myself.

Ocena
0 / 5
Polubienia
0
Pobrania
20
Wydruki
0
Wyświetlenia
139
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Home Decor
Licencja
Creative Commons — Attribution — Share Alike

This is for the Brillar series of LED strips commonly sold in Australian retailers. I have found that the remotes that came for these never had a wall mount or any way to mount them very effectively. A few iterations and a little design time later and I have this design that works well. 
Printing wise:
I used a brim on my older printer but on my new direct drives found that I didn't need one.
No infill is needed and I personally printed the final versions at 0.2 as they were getting puttied and sprayed.

 

*** Revisions

V1.0 – Original concept design, no real success in this other than establishing absolute failure.
V1.1 – Increased opening distance and added some branding. No easy way to attach to wall other than double sided tape. Didn’t print well 40% of the time in testing.
V1.2 – Useable results achieved after adding a backing, changing from sketch extrude to a extrude shell idea. This worked for the project and the images are based on this. Some failures and minor print issues.
V1.3 – Updated Clearances and added mouse ears to make easier to print well at high speed. Increased the opening width slightly to allow for minor over extrusion. 

Tagi