Pot Pod for flowers, plants, vegetable
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I designed this system of pod to isolate a bit my plants from the floor of our balcony (which can be too warm).
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 476
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
Why?
I designed this system of pod to isolate a bit my plants from the floor of our balcony (which can be too warm).
At the same time I integrated water reserve in the middle sections, which you can fill by the top. when the first reservoir is full, water goes down a level.
Side pod are connected to it by a hole and use of material.
The idea was to irrigate by capillarity, but I doubt it will work that way. What is more probable is that plants roots will use the material as a support/guide to the reservoir.
The middle section was not printed at the same dimension, but I put here to allow people try it. It printed well bigger so no obvious reason for a fail.
Print:
Material: PETG
0.2mm layers
Nozzle: 0.4mm
No support needed for me.
Not compatible with vase mode.
A bit of time. For example on my Prusa Mini, individual pods takes +/- 7h. Central sections between 11 and 15h.