Pot Pod for flowers, plants, vegetable
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I designed this system of pod to isolate a bit my plants from the floor of our balcony (which can be too warm).
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 25
- Makes
- 0
- Views
- 478
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution
Why?
I designed this system of pod to isolate a bit my plants from the floor of our balcony (which can be too warm).
At the same time I integrated water reserve in the middle sections, which you can fill by the top. when the first reservoir is full, water goes down a level.
Side pod are connected to it by a hole and use of material.
The idea was to irrigate by capillarity, but I doubt it will work that way. What is more probable is that plants roots will use the material as a support/guide to the reservoir.
The middle section was not printed at the same dimension, but I put here to allow people try it. It printed well bigger so no obvious reason for a fail.
Print:
Material: PETG
0.2mm layers
Nozzle: 0.4mm
No support needed for me.
Not compatible with vase mode.
A bit of time. For example on my Prusa Mini, individual pods takes +/- 7h. Central sections between 11 and 15h.