Macintosh SE and SE/30 SD card bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
SD card bracket for Macintosh SE and SE30
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 76
- Wydruki
- 0
- Wyświetlenia
- 445
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Description
I installed a BlueSCSI v2 into my SE/30, but i was missing the possibility to access the SD card. This bracket allows you to use an inexpensive SD card extender and mount it.
It's meant for use with a ribbon cable that extends a SDcard connection. You'll need to remove the plastic housing from the SD slot end, but these usually just clip together, and use some strong double-sided tape (like 3M VHB) to attach the SD slot to the bracket.
Compatibility
- Macintosh SE
- Macintosh SE/30
Printing
I printed the model with PLA without support and 20% infill. Depending on your printer some support is needed because of the relatively large opening of the SD card opening.
Parts
To install the bracket, you will need:
- SD card extender cable (like this)
- Two M3 nuts
- Two M3 screws (at least 8mm)
- Hot glue or double-sided tape (like 3M VHB 30mm)
Change Log
v1
- Initial release