Diagonal bicycle wall mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Pedal holder & wheel mounts for mounting a bicycle diagonally from a wall.
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 94
- Wydruki
- 0
- Wyświetlenia
- 1417
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
Pedal holder & wheel mounts for mounting a bicycle diagonally from a wall.
Would suggest making adjustments to the pedal holder via the cusomizer section that is specific to your bike. Basically make it narrower and shorter to accommodate your specific pedals. Also I left space for an image to be cut into the part, but it increases rendering time 100x so I commented it out. You need to find an image, I just used a bicycle line-art I found.
Would consider adding a 2nd screw hole to the pedal mounts as well as they tend to twist a bit.
Print Settings
Notes:
There was a lot of concern from colleagues over whether or not the parts would be strong enough to hold a bicycle, so I personally printed with Nylon at 50% fill on the bases and 30% fill on the pedal holder. The pedal holder is a bit too flexible, so I'd suggest printing at higher fill (or narrower/shorter). I've also printed a single pedal holder in ABS at 70% fill and have absolutely no doubt that it's strong enough. Could probably get away with a lot less fill on these.
Post-Printing
Category: Sport & Outdoors