Long Stupid Microphone for Game Show
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Prop microphone in 4 parts
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 109
- Wydruki
- 1
- Wyświetlenia
- 519
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Share Alike
I needed a long stupid microphone for a game show.
I hope it's long and stupid enough for your needs.
Recommendations
I elected to split the middle rod section down the middle and printed the two parts diagonally across the print bed (rod_2_parts.stl), combining them later with glue. If you can think of a better way to print it I've included the complete part (rod.stl). The base, rod and tip are held together by built in threads. These threads are a bit tight so I would encourage usage some form of grease to help them come together. I dabbed a bit of vegetable oil on the thread and it did the trick.
If the parts are too big for your print bed you could try scaling the parts down. The microphone wouldn't be as long but it would still be stupid.