1 / 5
PID REX-C100 case mount (remixed)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of an enclosure made by GreySID. The model has been changed to allow cable glands.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 91
- Wydruki
- 0
- Wyświetlenia
- 759
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is a remix of the REX-C100 case mount by GreySID. I have made the following changes which were more suitable for my needs;
- The four mounting holes in the corners have been increased from 4mm to 6mm diameter to accommodate larger screws.
- The enclosure walls have been reduced from 5mm to 3mm to save filament and print time.
- The mounting holes for the SSR have been changed so that the SSR can be mounted without a heat sink, straight into the box.
- Three holes have been made for three PG13 cable glands (two on top and one on the side), and another smaller one for a PG7 gland (thermocouple entry).
The original design has a M4 bolt and nut to secure the controller into the opening. Be careful not to over tighten this bolt (or use a bolt which is too long) otherwise it can deform the soft plastic enclosure of the REX-C100.