Filament holder for generic food dehydrator (Point/Progress/Anko)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Knobs, filament holder and lid holder for a generic food dehydrator that goes under the name Point/Progress/ANKO.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 421
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
If you're looking for a way to attach your food dehydrator to your Prusa-case, to use for drying filament, then look further! Because you probably don't have this exact model. It's a cheap dehydrator that goes under the name of “Point” in Norway. Also seen under the name “Progress” on Amazon (No longer available) or ANKO.
In any case, it attaches with 5 screwed in knobs of TPU, and the actual filament holder itself needs to be printed in at least the same material you are planning on drying. Aka, if you're planning on drying CF, it needs to made of it, as otherwise it will start to droop and melt when you turn the heat on max.
Two versions available: One with regular skateboard bearings, and one without. The bearings aren't strictly necessary, just nice to have.
There's also lid holders available, in case your lid isn't tall enough. I use a generic cake lid I found on Amazon that ended up not needing them.
If you find this specific dehydrator easily available internationally, or one similar enough to fit the same design, let me know