Healthy Rips HR Rogue Dosing Capsule Dispenser

Hey!

This is a dosing capsule dispenser that was modeled and inspired from the dispenser available for another vape (Healthy Rips Fury Edge Capsule Dispenser: https://www.printables.com/model/257828)

The dispenser holds capsules inside depending on the model selected, and when you pop a used one in, a new fresh one pops out the other end. So you ideally need the number of capsules for the model you printed to make it function properly (minimum 6 capsules for the model that holds 6). Or you can print some mock capsules (file included) to use as a filler or to separate your used caps with your new caps.

I loved this design and works well but the Edge capsules are slightly smaller. This will fit the bigger HR Rogue capsules perfectly.

_________________________________________________

Future plans:

• TBD

_________________________________________________

Versions:

• V1 (Not uploaded, fixed issues)
• V2 (Not uploaded, fixed issues)
• V3 Redesign to make it even easier to print and use less material. (11-July-2023)

_________________________________________________

Size Options: 

• Dosing Capsule Dispenser 4 - Holds 4 
• Dosing Capsule Dispenser 6 - Holds 6 
• Dosing Capsule Dispenser 8 - Holds 8
• Dosing Capsule Dispenser 10 - Holds 10
• Dosing Capsule Dispenser 12 - Holds 12

Not all size options have been tested. Please contact me if there's any issues and I will make the necessary adjustments

_________________________________________________

Print Instructions:

Body

• Print on its base. (Capsule slots facing up)
• I only enabled supports for the edge that holds the lid.
• I printed at .2 but you can change to any quality you want.
• 4 Walls
• Infill 35% (again, do as you wish)

Lid

• Print on its side! (This is to make it stronger so it doesn't break when it snaps shut. You can test printing upside down so the top is flat on the build plate, but I did not test. See pictures)
• Enable supports (make sure the supports are properly supporting the connection to the body and the snap.
• I printed at .2 but you can change to any quality you want.
• 4 Walls
• Infill 35% (again, do as you wish)

Capsules (Optional)

• Print as many as you require. They are not needed but I like have 1 separator, so I know when I'm out of new capsules and the used ones don't get mixed. prevents having to open a capsule to double check.
• I printed at .2 but you can change to any quality you want.
• 2 Walls
• Infill 10% (Triangle infill, or as you wish)

_________________________________________________

Post Processing: 

You might need to file some edges if your supports didn't works as well. Just to make the parts smooth.