1st Gen Mini Cooper (R50, R52, R53) Speed Sensor Spacer for 2nd Gen Trailing Arms
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small spacer for the speed sensor inserted into 2nd gen Mini Cooper aluminum trailing arms
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 126
- Wydruki
- 1
- Wyświetlenia
- 1989
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
A common upgrade for 1st gen MINI Coopers is to swap out the steel trailing arms for the cast aluminum arms on the 2nd gen cars. In order to continue using your first gen speed sensor that inserts into the new trailing arm, you need a small spacer to ensure the sensor remains centered within the now larger hole. This spacer slides onto the existing speed sensor and then spaces the sensor exactly in the middle of the larger hole on the new aluminum trailing arms. You will need two of these small spacers (one for each trailing arm) and they do not need to be printed with any special settings.
When installed, they are located near the rear wheel hub assembly so there may be some heat transferred through the aluminum trailing arm, but I doubt it would ever get to a point where you would worry about melting and there is no room for deformation. As such PLA should be fine but I went with ASA just to be safe.