1st Gen MINI Cooper Rear Headlight Level Sensor Bracket for Aftermarket Control Arms
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A two-piece bracket to connect light level sensor to round, aftermarket control arms.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 578
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
The 1st gen MINI Coopers use a folded steel control arm design and the light-level sensor in the rear left of the car is connected to the lower control arm via a bolted-on bracket. If replacing the control arms (for adjustable aftermarket arms), the light level bracket no longer can be easily attached. Some people have had success with zip ties or hose clamps but this 3D printed clamp makes for a more secure fit.
The design has four (4) holes to allow for 5mm long threaded M3 heat inserts and can be mounted to the control arm with four (4) 25mm M3 bolts. The sensor arm is then attached to the brack using the original bolt and nut found on the car.
The bracket's inner diameter is just over 1 inch (26mm) and should be usable for a large majority of round, aftermarket control arms.
Note: The bracket is located close to the rear exhaust and as such should be printed out of a higher temp plastic (ABS, ASA, PC, Nylon).