Vasemode trashcan for freezer bags
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple trashcan that uses freezer bags to be printed in vasemode.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 68
- Wydruki
- 0
- Wyświetlenia
- 343
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A simple trash bin that uses freezer bags (3liters, ~25cm width when flat) as garbage bags. I primarily use it for filament waste (failed prints, P1Ps poop, purge line). The bin will deform to fit parts bigger than its diameter (160mm), but it will not break. Its height is 250mm, which is the maximum print height of my P1P, although it can be scaled to any height. I use differently colored cans for PETG/PLA, so I can separately send them to a recycling facility. You can also use it as a practical test to see how thick of a line your printer can handle.
Print settings:
Vase mode: Enabled
Bottom Layers: 1
Layer height: 0.32mm
Line width: 0.8mm
Filament: PLA (any will work)
Filament used: ~110g