1 / 4
Nema23 shroud for GX16 connector — zdjęcie 1
1 / 4

Nema23 shroud for GX16 connector

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Snap on shroud for nema23 stepper motors that can hold a gx16 connector.

Ocena
0 / 5
Polubienia
5
Pobrania
30
Wydruki
0
Wyświetlenia
212
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Snap on shroud for nema23 stepper motors that can hold a gx16 connector.
Makes it easy to wire stepper motors, in my case for a cnc router by adapting the 4 wires from a nema23 stepper to a single cable. The 4 wires are cut to length (~10cm) and soldered to the connector. 

Assembly:

  1. Make sure the connector fits through the hole on the printed part (some filing might be necessary)
  2. Put the nut for the connector and heat shrink tubes over the stepper wires
  3. Pull the wires through the hole on the printed part and cut them to length
  4. Solder the wires to the connector
  5. Fasten heatshrink over soldering contacts
  6. Secure the connector with the nut
  7. Stow the remaining cable in the connector box
  8. Push part onto the stepper

Print settings:

  • Layer height: 0.3mm
  • Infill 15%

Supports should be printed within the “cable-box” where the connector sits.
Support settings:

  • Style: snug
  • Pattern spacing: 3mm
  • XY spearation: 1.5mm

 

Tagi