The filter with HEPA filter -- Single Fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
this is a remix from the original model from nateb16 that aims to include an HEPA filter to his awesome mod
- Ocena
- 5 / 5
- Polubienia
- 42
- Pobrania
- 111
- Wydruki
- 2
- Wyświetlenia
- 1208
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- GNU General Public License v3.0
- This remix aims at including the standard HEPA filter already used by the voron community in this mod (VEFACH)
- If you wish to buy HEPA filter used by this mod you can find them on aliexpress
- I reccommend these 5015 fans to be used with this mod and the filter i have found them to be quite effective.
I have currently not designed the magnetic pogo pin in this model as it is quite hard to fit in the back of my 300mm voron 2.4 but if enough people want it I can design one.
Once the upper plate has been placed, it will be hard to remove (this is done so that most of the air will pass through the HEPA filter)
Thus, i think that to change carbon pellets it is best to only remove half of the plate like in this picture below :
Make sure to place the HEPA filter in the right way with the tab facing up for easier removal once consumed.
Again, thanks a lot to Nateb16 for his awesome model !