Pistol grip camera for the Raspberry Pi HQ camera module
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This was an early experiment with a novel form factor for the Raspberry Pi HQ camera.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 466
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Share Alike
Building a Raspberry Pi HQ camera module into a pistol grip chassis. It's really hacked-together as a learning exercise for OpenSCAD, so it's by no means perfect. It's thus a work in progress, and some bits might improve over time.
Update 2020-07-01: improved locating foot and shoe tolerances.
Update 2020-07-07: Improved strength of locating shoe on handle
You'll need four M2.3x8mm self-tapping screws to fit the camera. The sloping top is designed to mount a Raspberry Pi in a case using Velcro strips. I'm using a cheap touchscreen for the interface. The handle can take a battery, its designed to fit two 18650s in holders but I use a single 18650 booster pack.
The pistol grip screw cap uses the necks and caps library by [Xavan], under a CC BY 4.0 licence, from https://www.thingiverse.com/thing:1654620
All OpenSCAD files as well as ongoing work with software can be found at https://github.com/JennyList/PistolGripCamera
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
Yes
Resolution:
Draft
Infill:
20%
Filament: Generic PLA
Category: Camera