Dryer Duct Poop Chute For Bambu Labs Printers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Poop chute for Bambu Labs printers that uses a standard American dryer vent hose, 4 inches in diameter.
- Ocena
- 5 / 5
- Polubienia
- 28
- Pobrania
- 151
- Wydruki
- 0
- Wyświetlenia
- 2656
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to design a poop chute for my Bambu Labs X1C that did not fill up half way through a print. I was getting pretty tired of prints pausing in the middle because of poop building up in the excess chute. I even had a few times where the poop fell onto the print bed and caused the ‘spaghetti detection’ to pause the print.
With this design, any waste bucket of any size will work. You simply need to attach the chute to the back of the printer, and attach a dryer hose to the printed chute using a pipe clamp or zip tie. I used reusable plastic clamps for mine, but permanent ones will work too. The hole in the top of the chute is for clearing jams if any occur, so far none have for me. The model has holes inside it to embed magnets into the chute. There are 12 holes total, made to fit 8mm magnets. I used two 8 x 1 magnets in each hole, because that's what I had on hand, but I would recommend using 8 x 2mm magnets instead. I also recommend buying the strongest possible magnets you can, even with 24 magnets in my print it still slides and shifts around from time to time. If it becomes a problem, I will just add a small piece of double sided tape to keep it in place.
This is the third revision of this print, so hopefully it does not need any more changes. I plan on designing another part to fix the hose in place on the bin, but that will not be finished for some time.