Trust Trino HD Webcam Voron Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This replaces the Trust Trino HD webcam's case with a compact, 2020 extrusion attachable, replacement.
- Ocena
- 3 / 5
- Polubienia
- 7
- Pobrania
- 73
- Wydruki
- 2
- Wyświetlenia
- 832
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This mod allows you to mount a Trust Trino HD webcam (available for ~EUR10 on Amazon) on a 20x20 extrusion using standard Voron mounting hardware.
It consists of a full replacement case which does away with much of the bulk, removes the microphone, and can be easily mounted at a range of angles on a standard 20x20 extrusion with M3x8 SHCS and M3 hammerhead nuts or M3 T-nuts depending on your preferences. Camera angle can be adjusted along the extrusion axis, making this ideally suited for mounting at the top of your printer frame (on something like a Voron 2.4).
Version 2 has been updated to improve both the cooling and shape, making the whole assembly a little bit more compact and aesthetically pleasing.
Bill of Materials
- 6x M3x8 SHCS
- 2x M3 T-nut / M3 hammerhead nut
- Self tapping screws from Trino HD
Printing Suggestions
Print with 40% infill, 4 perimiters, 5 top/bottom layers. Remember to print two “mounts”, one for either side of the case.
Assembly Instructions
- Remove the front panel of your Trust Trino HD webcam by removing both of the rear screws (one may be under a QC sticker).
- Remove the screws holding the circuit board, allowing you to gently remove it from the read case. Retain these screws for use later.
- Unplug the microphone from the circuit board, allowing you to fully remove the front panel/lens assembly.
- Carefully cut through the rear case to free the cable, using side-cutters or similar. Be careful not to cut the USB cable.
- Mount the circuit board face-down in the front frame component, using the screws from (2) to affix it in place.
- Carefully attach the rear frame component, ensuring that the cable tie on the USB cable is within the frame to provide strain relief. Use 2x M3x8 SHCS to screw the pieces together. Be careful with screw torque here as these screw directly into plastic.
- Screw the mounts onto the side of the rear frame component using 2x M3x8 SHCS bolts. Be careful with screw torque here as these screw directly into plastic, and leave some slack to allow adjusting the camera angle.
- Attach the mounts to the frame extrusion using 2x M3x8 SHCS and 2x M3 T-nuts.