Skådis / Skadis - Pliers and Cross Cuts Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Skadis mountable holder for Pliers or Cross Cuts (or anything else that fits).
- Ocena
- 4,571 / 5
- Polubienia
- 45
- Pobrania
- 349
- Wydruki
- 9
- Wyświetlenia
- 1231
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
Use with Ikea Skadis system and T-Clips to mount (see remix section).
Be sure to print a T-Clip to go along with this model.
Should be usable with most Pliers and Cross Cuts (or anything else with a similar shape between the handles).
After inserting the T-Clip fully, turn the printed model on its side, attach it to the Skadis board, and rotate clockwise 90° or until the printed model is in the correct orientation. Do not overtighten the model or the T-Clip might bend/break. If so, simply print a replacement T-Clip.
To remove, turn the printed model counterclockwise 90° and pull outward.