1 / 1
Tamiya Blitzer Wheels 2.2 and 2.2/3.0 SCT 2WD — zdjęcie 1

Tamiya Blitzer Wheels 2.2 and 2.2/3.0 SCT 2WD

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Two sets of wheels for the Tamiya Blitzer Beetle, but should also fit Stadium Blitzer and Stadium Thunder and mostly…

Ocena
0 / 5
Polubienia
12
Pobrania
155
Wydruki
0
Wyświetlenia
2014
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial

Two sets of wheels for the Tamiya Blitzer Beetle, but should also fit Stadium Blitzer and Stadium Thunder and mostly likely other 2WD Tamiya models which have ball-bearing front wheels rather than the 12mm hex found on most aftermarket wheels.

The 2.2 wheels are basically stock replacements.

The SCT wheels I designed because I couldn't find replacement rear tires to fit the stock wheels. They are 2.2"/3.0" diameter and 42mm wide with 12mm hex drive in the rear and freewheel on 5x11x4 bearings in the front.

Print face up at 100% infill with support under only the hub area only.

Print instructions

Category: R/C Vehicles Summary

Two sets of wheels for the Tamiya Blitzer Beetle, but should also fit Stadium Blitzer and Stadium Thunder and mostly likely other 2WD Tamiya models which have ball-bearing front wheels rather than the 12mm hex found on most aftermarket wheels.

The 2.2 wheels are basically stock replacements.

The SCT wheels I designed because I couldn't find replacement rear tires to fit the stock wheels. They are 2.2"/3.0" diameter and 42mm wide with 12mm hex drive in the rear and freewheel on 5x11x4 bearings in the front.

Print face up at 100% infill with support under only the hub area only.

Print Settings

Supports:

Yes

Infill:

100

</div>

Notes:

Support needed under hub area only.

Tagi