Bottom Protective Cover for Magnifying Lamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This part is a protective cover to protect the bottom side of the lens of Velleman/Elix magnifying lamp.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 344
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
1. Introduction
I recently bought a magnifying lamp for my fabrication lab in order to check pcb and small details here and there. Very useful !
In most of this kind of lamps, the top of the lens can be protected by an attached cover when you are not using the lamp. In this way, dust and debris can't accumulate on the lens if the lamp is set horizontally.
However, if you want to fold up completely to spare some space on your desk like me, the bottom will now be exposed to dust and debris too. And maybe to some stupid movements from my elbow ;p
That's why I designed this little cover, which can be attached magnetically and removed very easily when you desire.
2. Revision History
| Version | Description | Date |
|---|---|---|
| A.1 | Initial Release | 18/07/2023 |
3. Printing Instructions
- Element
- PETG.
- Layer Height: 0,2 mm
- Min 2 perimeters
- No supports
- Min 20% infill
- Infill Pattern: Gyroid
- Top and Bottom Pattern: Archimedean Chords
4. Materials for Assembly (BOM)
- The printed parts
- Your magnifying lamp
- 3x Neodymium Magnet N42 4mm diameter x 3 mm height (0,54kg Pull Force)
- A little bit of glue (Cyanoacrylate)
5. Assembly Instructions
- Fully insert the three magnets into the dedicated holes. No glue is required here.
- Flip of the part and glue the little handle into the rectangle slot. Wait a couple of minutes to let the glue cure.
- Test the part with the magnifying lamp. It should hold and stay in place. A little force must be required to remove the cover at each magnet location. If it is not the case, you need to adjust the little metal strips of the lamp to bring them closer to the magnets location.
5. Notes
- The design was made for Velleman/Elix Magnifying lamps. It should work for other clones too of the lens diameter is about 130mm, the lens "window" 127mm and if three metal strips are present to hold the lens.
- G-code file only made for MK3S+. The file contains some custom lines to add a pre-heating before the printing to avoid oozing during the mesh bed levelling. And a timer at the end of the print to buzz a sound once the parts has cooled down.
- Do not use the g-code file on other machines than MK3S+ ! In any case, I recommend you to slice the .stp files by yourself to make your own g-code files.
Have a nice print !
Last note! I've spent quite a lot of time designing, iterating and prototyping on all my models. Therefore, if you enjoy them, please don't forget to like+download and then rate them, so that I can earn so prusaments to continue ;)