Reverb G2 head strap fix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An easy-to-print head strap fix for the HP Reverb G2
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 65
- Wydruki
- 0
- Wyświetlenia
- 576
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The head strap fixation on my Reverb G2 broke, so here is an easy-to-print quick fix, as the official spare part is nowhere found…
It can be secured with a small overlapping piece of duct tape on the top, but on my headset it's not required.
Prerequiste:
You'll need to “trim” the broken old fixation, the horizontal part (the fragile one) must be gone at 100%.
Tested printing settings:
tested on: BambuLab P1P
material: matte PLA but ABS will be fine too if you can print it
raft: yes
supports: yes (std supports, >40°)
layer: 0.12mm but you can go higher
infill: honeycomb/gyroid 50% and it seems solid
With these settings, it takes 40min to print and uses 9g of PLA