HSW Cable Organizer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Loved the easy design and print of the KLIPPT and adapted it for my under-desk HSW solution.
- Ocena
- 5 / 5
- Polubienia
- 150
- Pobrania
- 487
- Wydruki
- 4
- Wyświetlenia
- 2513
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
Loved the design and print of the KLIPPT and adapted it for my under-desk HSW solution.
Print Instructions:
The compliant hinge will work best with PETG, but ABS, ASA or even PLA will work as well but may break if open/close-cycled too often. This model is optimized to be printed with a 0.4 mm nozzle using the Arachne slicing Engine. Please dial in your filament to ensure proper fitment.
Install Instructions:
Klippt Parallel: has end-stops on one side (identified in beginning of gif), identify the side with the smaller nibs. Open the latch and compress/flex/bend the bottom part by applying force, so that the middle section becomes straight. Then slide the hook onto the KLIPPT from the side with the smaller nibs.
Klippt Perpendicular: Flex the clip as described above, insert one side of the hook perpendicular to the opening.
HSW Installation: The hook attachment has a arrow designed onto it. Insert that side onto the HSW first AT AN ANGLE and push to snap into place. Similar to the gif below.
