HSW Cable Organizer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Loved the easy design and print of the KLIPPT and adapted it for my under-desk HSW solution.
- Rating
- 5 / 5
- Likes
- 150
- Downloads
- 487
- Makes
- 4
- Views
- 2,513
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial
Loved the design and print of the KLIPPT and adapted it for my under-desk HSW solution.
Print Instructions:
The compliant hinge will work best with PETG, but ABS, ASA or even PLA will work as well but may break if open/close-cycled too often. This model is optimized to be printed with a 0.4 mm nozzle using the Arachne slicing Engine. Please dial in your filament to ensure proper fitment.
Install Instructions:
Klippt Parallel: has end-stops on one side (identified in beginning of gif), identify the side with the smaller nibs. Open the latch and compress/flex/bend the bottom part by applying force, so that the middle section becomes straight. Then slide the hook onto the KLIPPT from the side with the smaller nibs.
Klippt Perpendicular: Flex the clip as described above, insert one side of the hook perpendicular to the opening.
HSW Installation: The hook attachment has a arrow designed onto it. Insert that side onto the HSW first AT AN ANGLE and push to snap into place. Similar to the gif below.
