Tamya battery connector Tool
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
You push in the front, until the tabs of the connector are pushed in by the tool. Then, through the hole at the back you
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 189
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
You push in the front, until the tabs of the connector are pushed in by the tool. Then, through the hole at the back you push the connector through with a slim screwdriver. If the cable is still attached, you can also pull the connector out by it.
you might have to scale the model up by like 5%, as most FDM printers print circles smaller than they should be.
For Print settings i recomend a brim and Vase Mode for the best results. I used 0.2 mm layers but 0.1 mm layers can yield a better result frictionwise.