1 / 4
Tamya battery connector Tool
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
You push in the front, until the tabs of the connector are pushed in by the tool. Then, through the hole at the back you push the connector through with a slim screwdriver. If the cable is still attached, you can also pull the connector out by it.
you might have to scale the model up by like 5%, as most FDM printers print circles smaller than they should be.
For Print settings i recomend a brim and Vase Mode for the best results. I used 0.2 mm layers but 0.1 mm layers can yield a better result frictionwise.