Amphibious Car Paddlewheel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Paddlewheel to fit over existing amphibious car wheel - no supports
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 186
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
My kids have amphibious RC cars. They're really fast on land, but they are really slow on water because the fins built into the wheels don't have much surface area.
I decided to build some snap-on paddlewheels with extra-large fins for using in the pool. I designed them to extend past the other wheel on the same side so they'd have a larger diameter, so I only put fins on the front wheels (all four wheels drive). They definitely improve the speed of the car in water. I could make them bigger, but I don't know if the car has enough torque to handle the extra load.
I printed the wheels in black PETG with a 0.3mm layer height.
They are designed to fit over ~100mm diameter wheels. The ID of the snap-on wheel is 103, which fits pretty tightly against the rubber ring on the edge of the wheel. If your wheels are a different size, I would expect scaling the model to work fine for you. There are also 15 slots to fit over the existing fins on the wheel, so if your wheels have a different number, it would probably be a problem for you. If so, let me know and I can tweak the design to make it work for any other number.