[REMIX] 6 Tier Tech Deck Finger Board Display Stand | Fits All Fingerboard Sizes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fits all Tech Deck sizes, remixed from the standard 3 tier stand from Penguino
- Ocena
- 5 / 5
- Polubienia
- 69
- Pobrania
- 976
- Wydruki
- 2
- Wyświetlenia
- 2986
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
It’s nice and sturdy, and you can move it around without worrying about it falling forward. This is only a problem for me because I've been playing with them a lot recently and swap decks normally. I also added a copy without the Tech Deck Sign in case you don't want the sign there.
it fits a total of 6 completes. It fits all size Tech Decks including the older smaller decks(girl deck in pic is this size), and the newer decks that are a little larger(the other 5), as well as the Pro Series Tech Decks, and of course professional fingerboards.
I printed at .2 Layer Height, 15% infill, PLA, on a steel PEI sheet. I had to print it pretty slowly to prevent curling, so I would recommend going much slower than usual if you're using an older printer. Also, I found that the overhang can be tricky if you're using a Bambu printer, so while it can certainly print fine without supports, you can opt to use them if you want to.
(I didn't enable Z hop, but I might recommend doing so because the nozzle would hit the model and it would kind of wobble mid print, so it might be a good idea but may increase stringing. Mine came out fine but I was a nervous wreck mid print because I was afraid it might fail from getting hit by the nozzle lol)
If you print one post a make, I would love to see it!
-Darth Tommy