[REMIX] 6 Tier Tech Deck Finger Board Display Stand | Fits All Fingerboard Sizes
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Fits all Tech Deck sizes, remixed from the standard 3 tier stand from Penguino
- Rating
- 5 / 5
- Likes
- 69
- Downloads
- 969
- Makes
- 2
- Views
- 2,955
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
It’s nice and sturdy, and you can move it around without worrying about it falling forward. This is only a problem for me because I've been playing with them a lot recently and swap decks normally. I also added a copy without the Tech Deck Sign in case you don't want the sign there.
it fits a total of 6 completes. It fits all size Tech Decks including the older smaller decks(girl deck in pic is this size), and the newer decks that are a little larger(the other 5), as well as the Pro Series Tech Decks, and of course professional fingerboards.
I printed at .2 Layer Height, 15% infill, PLA, on a steel PEI sheet. I had to print it pretty slowly to prevent curling, so I would recommend going much slower than usual if you're using an older printer. Also, I found that the overhang can be tricky if you're using a Bambu printer, so while it can certainly print fine without supports, you can opt to use them if you want to.
(I didn't enable Z hop, but I might recommend doing so because the nozzle would hit the model and it would kind of wobble mid print, so it might be a good idea but may increase stringing. Mine came out fine but I was a nervous wreck mid print because I was afraid it might fail from getting hit by the nozzle lol)
If you print one post a make, I would love to see it!
-Darth Tommy