DigiComp I Logic and Clock Tubes, Wire Jig, Slider
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Logic and Clock tubes for original DigiComp I plastic computer. Also: a jig for making more vertical rods, and a slider
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 527
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
These tubes fit the logic and clock tabs of the DigiComp I plastic computer. They're used to program it.
I printed with white PLA.
Note that the clock and logic tabs on the DigiComp I flip-flops appear to be a little non-uniform in size, and my replacement logic and clock tubes are not as compliant as the original thick-wall plastic "straws" on the original. This means you may have to fiddle with them a bit, and pick the best-fit tube for a tab when programming.
The horizontal logic tube is designed to be printed laying down without support.
The wire jig is for bending more clock rods and logic rods, a crank, and the vertical pin that holds the whole machine together.
The slider is for printing spares of the sliders that run across the top of the machine. It's a simple single slider - not the double “OR” slider.