1 / 1
Organic Support Pot with Drainage — zdjęcie 1

Organic Support Pot with Drainage

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I loved the original pot, but I added 8 holes to allow water to drain out into the outer tray where the organic supports

Ocena
5 / 5
Polubienia
18
Pobrania
213
Wydruki
5
Wyświetlenia
853
Oceny
4

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Same as “Tree support planter pot” but with 8 drainage holes to the outer tray.

I added the instructions below from the comment section for easy access:

1) Paint supports around the rim (I like the triangles option)

2) Under Print Settings -> Support Material -> Options for support material and raft Set "Top contact Z distance" to "0 (soluble)"

3) Set the following under "Organic Supports"
- Maximum Branch Angle = 25
- Preferred Branch Angle = 20

4) Make sure "For Support Enforcers Only" is selected on the main page.

You may have to tweak the settings on step 3, but after a few trial and errors, I believe those listed are near the threshold needed to both maximize the tree-like shape and keep them inside the pot.