Organic Support Pot with Drainage
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I loved the original pot, but I added 8 holes to allow water to drain out into the outer tray where the organic supports
- Rating
- 5 / 5
- Likes
- 18
- Downloads
- 213
- Makes
- 5
- Views
- 853
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Same as “Tree support planter pot” but with 8 drainage holes to the outer tray.
I added the instructions below from the comment section for easy access:
1) Paint supports around the rim (I like the triangles option)
2) Under Print Settings -> Support Material -> Options for support material and raft Set "Top contact Z distance" to "0 (soluble)"
3) Set the following under "Organic Supports"
- Maximum Branch Angle = 25
- Preferred Branch Angle = 20
4) Make sure "For Support Enforcers Only" is selected on the main page.
You may have to tweak the settings on step 3, but after a few trial and errors, I believe those listed are near the threshold needed to both maximize the tree-like shape and keep them inside the pot.