DJI RC Remote Case (the one with display) - Magnetic Close

First of all a big thanks to @Avalance_27902 for the original design, as can be found here.

I've made some improvements to make it more functional and practical (at least in my eyes). My new version has the following major changes/features:

1. Added hinges to the model so no tape is needed
2. Added a magnetic locking system (either use 6x2.5 or 6x3 magnets, you'll need 4 of them)
3. Added a larger “foot” so the case can stand upright without toppling over, this works both with and without the remote in the case
4. Slightly increased the case width with 2.5mm, I find the original just too tight and this allows for some room to add some internal padding (I'm working on some printable TPU padding, will upload when done and tested!).

The version in the photos in printed with PETG (orange so it stands out in my backpack and can easily find it during hiking). This might be required, because you will need to force the lid into the hinge of the case, for which the material needs to be a little bit flexible. Feel free to test with other materials and let me know the results!

I've printed with 0.16mm layer height, to increase the smoothness of the model for easier sliding in/out of the remote and reduced chance of “sanding” it.

Printed on Bambu X1C, so if tolerances are too tight, please let me know. But should be fine because I kept the same as the original :-)

Enjoy and looking forward to your feedback!