LLTT – the ultimate LACK Leg Turning Tool (FreeCAD)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
… tired of attaching all those LACK table legs by hand?
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 18
- Wydruki
- 1
- Wyświetlenia
- 245
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
10 (ten) new LACK tables in the house and I know how cumbersome it is to screw in the legs. That pain 40 times? 😣 There must be a better solution, … so here it is:
LLTT — the ultimate LACK Leg Turning Tool
Printing
PETG, 0.4 mm nozzle, 0.3 mm layer height, 3 perimeters, arachne, cubic infill w/ strengthening modifiers, brim, no support
(see .3mf attached)
Most likely printing with less material will be good enough. But I just didn't want to try this out…
Additional material
- 1 pcs M8 threaded rod, at least 75 mm long
- 1 pcs M8 cap nut, DIN1587
- 2 pcs M8 washer, ISO7089
- 1 pcs M8 hex nut
You also need an electric screwdriver / drill. ;)
Assembly
(see image 😉)
Tighten the nuts as much as possible, use thread lock if at hand.
Before screwing in the bolt you can grind down the thread on the shaft that goes in the drill: put the rod in the drill and spin it while pushing the end against a grinder. So you easily get a smooth and round shaft.
