Work Light - Yellow
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This portable yellow work light was sold on eBay and used three included 18650 batteries. The work light underperformed.
- Ocena
- 0 / 5
- Polubienia
- 24
- Pobrania
- 90
- Wydruki
- 0
- Wyświetlenia
- 1435
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
This portable yellow work light was sold on eBay and used three included 18650 batteries. The work light underperformed. This document describes a re-engineer of much of the work light. The rebuild makes it brighter and adapts it to work with Makita 18V LXT batteries.
The rebuild elevates the light’s performance to a higher level and is finished with a 3D printed enclosure for the new electronics and the Makita battery fitting.
To make the work light brighter, I replaced the original LED module with a low cost 50W COB LED module. This new COB needed to work with my Makita 18V LXT battery, so new electronics were integrated into the design.
Where the site allows, for those interested in part or all the workings, I've included a document describing the design and wiring.
My print is made in PETG 1.75mm 3DFillies orange filament, with 0.2mm layer height and 100% infill on a PRUSA I3 MK3S printer.
I hope you can find this design useful, too.
Remember to leave me some feedback or even a tip to keep me enthused to make more of these drawings.
Print instructions
My print is made in PETG 1.75mm 3DFillies orange filament, with 0.2mm layer height and 100% infill on a PRUSA I3 MK3S printer.