Stackable Organizer System

This is a little system of different sized containers. The design goals are the following:

• Look nice so it can be left out visible on the desk, dressing table or bath room. No obvious 3D-printed vibes.
• Form over space optimization.
• Easy and fast to print but still sturdy enough.

The system is rectangular/square but with very chamfered and rounded corners, walls gently tapered. There are 3 different side lengths (80mm, 100mm and 180mm) and 5 different heights (36mm, 50mm, 84mm, 132mm and 180mm). Every variation of these dimensions are available for download as an STL file.

There are also two lid options:

• Slick lid: Sits very neat and flat on top of container. Finger hole for easy opening, lid just rests in place.
• Stackable lid: Similar but with a slightly raised edge so that other containers or objects can be stored on top without sliding off. Containers within their own base size can be stacked without lid.

Other notes:

• Those models I frequently print and use are marked as my favorite in the file comment. I don't have that much experience with the taller versions like 132mm and 180mm.
• I print these as fast as I can at 0.3mm layer height. A “galaxy” type or similar layer line hiding filament is recommended.
• All STL models are already in the recommended print orientation.
• The 50mm height is special in that when stacked with another size, the sum equals the next larger size. For example: H36 + H50 = H84 (when stacked without lid).