Hex driver bit handle with an embedded magnet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed to add a pocket for an 8mm x 3mm round magnet and a loop hole for small cordage.
- Ocena
- 5 / 5
- Polubienia
- 30
- Pobrania
- 163
- Wydruki
- 8
- Wyświetlenia
- 663
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
I've also included a gcode file for a Prusa Mini/Mini+ which has a Pause At Height for letting you put in the magnet. Note: The pause occurs approximately 21 minutes into the print.
CAUTION: I'm not sure if it's an issue with the Prusa Mini's firmware or an Octoprint problem, but the M601 command doesn't work if you print the gcode file from Octoprint to the Mini. It does work though, if you load it onto a USB flash drive and print from there.
FYI, here's some info on the M601 issue: https://forum.prusa3d.com/forum/hardware-firmware-and-software-help/pause-m601-not-working/
2025-02-18: If you want to use your 4mm hex bits, you can find my 4mm to 6.35mm adapter sleeve here: https://www.printables.com/model/1197861-4mm-to-635mm-hex-bit-adapter-sleeve
2023-08-01: Added a version with a loop hole for attaching to a keychain.